Dy-8 датер инструкция по эксплуатации

dy-8 датер инструкция по эксплуатации
You may use LEFT and RIGHT buttons to adjust brightness of your display to your desired level. Lines of up to 70% permenant packet loss are still sufficient to get the data out, albeit a bit delayed sometimes. Enable on VRM NoEnable on VRM allows connection to the CCGX anywhere through the VRM portal.


Remote console Enable password check Enable and set password authentication to access to the remote console. The user can change the time of energy saving mode activation.Acceptable values:OFF — the energy saving feature is turned off.1, 5, 10, 15, 20, 25, 30, 35, 40, 45, 50, 55, 60 — delay time (in minutes) for energy saving mode activation. Stored backup firmware With this feature you can go back to the previously installed firmware version. The difference between the DC current measured by the Multi and by the BMV will be attributed to a ‘DC system’. It can be an alternator, pumps, DC fridge, etcetera. Make sure to use router that is designed for unattended setups. Do not use low cost consumer-grade routers, intended for business or leisure travel. Reticle Selection Menu > Display > ReticleReticle – all Reticle settings including the Zeroing-in of your X-Sight are located here.Reticle Display – you may turn the Reticle ON or OFF. Turning the Reticle off may be useful when using the X-Sight for observational purposes only.

His solution is using a VPN and he modified the IP routing table to route ALL traffic to and from the CCGX via his VPN. Using a firewall at the VPN server allows him to control traffic according to time, connection type, place and destinations. You can see that it’s active in the settings menu: When using this external memory, it will still make use of an active internet connection to send its backlog. Should the storage space run out, no more data is logged.

Похожие записи: